![](/uploads/1/2/5/1/125185519/169321430.jpg)
How to Program a Ford Mustang Keyless Entry Remote FOB. Turn the key in the ignition to the on position and then back to the off position 8 times using a rapid pace. If you have done this correctly the doors will lock. Now push a button on the remotes that you wish to program. Do not push more than one button and make sure to push one on each remote. Free Step-by-Step How To Programming & Memory Clearing Instructions for a 2010 Jeep Wrangler Keyless Entry Remote Fob. Verify that this important information is on the back of your remote before using these programming instructions. FCC ID: OHT692427AA, OHT692713AA. Factory Part No.: 68001702AA, 05026104AB.
The auto lock feature on Ford vehicles can be both a blessing and a curse. Though they provide you the added safety of locking your doors as you travel down the road, you may not always realize the doors are locked when you exit the vehicle and could accidentally lock yourself out of the car. Disabling the auto lock feature can save you from having to call a locksmith.
Step 1
Get into the car and close all the doors. Insert your key into the ignition, but leave it in the off position. Make sure the perimeter alarm is disabled before you attempt to disable the auto locks, because the perimeter lock could interfere with the process.
Step 2
![2010 Mustang Horn Beeps When Programing Key Fob 2010 Mustang Horn Beeps When Programing Key Fob](/uploads/1/2/5/1/125185519/262738611.jpg)
Turn the key to the on position and press the power door lock button three times in a row. Turn off the ignition switch and press the power door lock button three times. This process notifies the vehicle's computer system that you want to enter into enable/disable mode. Return the ignition to the on position and listen for the horn to chirp. This horn lets you know the vehicle is ready for the next stage.
Step 3
Push the power door unlock button once to turn on the auto lock feature. Press the power door lock button once and listen for the horn to beep one time. One beep confirms the auto locks have been disabled. Two beeps, one short and one long, signals that the auto locks have been enabled, so if you receive two beeps, start the process over again.
Turn the car off and listen for the horn to beep. One beep of the horn confirms that changes have been made to the auto lock system.
Tips
- After entering into alteration mode, you have 30 seconds to make the changes. Taking too long to perform the change could cause you to have to start over again.
- This process should work with all modern Ford vehicles.
![Fob Fob](/uploads/1/2/5/1/125185519/822079239.jpg)
More Articles
![](/uploads/1/2/5/1/125185519/169321430.jpg)